Tel:
+86 29 8177 9287 (English)
+86 29 8177 9276 (Español)
+86 29 8177 9280 (Русский)
LED learning center
  • Brief Introduction of Category 5 Cable
  • 17-07-2012

Category 5 cable (Cat 5) is a twisted pair cable for carrying signals. This type of cable is used in structured cabling for computer networks such as Ethernet. It is also used to carry other signals such as telephony and video. The cable is commonly connected using punch down blocks and modular connectors. Most Category 5 cables are unshielded, relying on the twisted pair design and differential signaling for noise rejection. Category 5 has been superseded by the Category 5e (enhanced) specification.

The specification for Category 5 cable was defined in ANSI/TIA/EIA-568-A, with clarification in TSB-95. These documents specified performance characteristics and test requirements for frequencies of up to 100 MHz. Cable types, connector types and cabling topologies are defined by TIA/EIA-568-B. The cable is terminated in either the T568A scheme or the T568B scheme. The two schemes work equally well and may be mixed in an installation so long as the same scheme is used on both ends of each cable. Nearly always, 8P8C modular connectors, often referred to as RJ45, are used for connecting category 5 cable. The USOC/RJ-61 standard is used in multi-line telephone connections.

Each of the four pairs in a Cat 5 cable has differing precise number of twists per metre to minimize crosstalk between the pairs. Although cable assemblies containing 4 pairs are common, Category 5 is not limited to 4 pairs. Backbone applications involve using up to 100 pairs. This use of balanced lines helps preserve a high signal-to-noise ratio despite interference from both external sources and crosstalk from other pairs. Category 5 cabling is most commonly used for faster Ethernet networks, such as 100BASE-TX and 1000BASE-T.

The cable is available in both stranded and solid conductor forms. The stranded form is more flexible and withstands more bending without breaking and is suited for reliable connections with insulation piercing connectors, but makes unreliable connections in insulation-displacement connectors (IDCs). The solid form is less expensive[citation needed] and makes reliable connections into insulation displacement connectors, but makes unreliable connections in insulation piercing connectors.[clarification needed] Taking these things into account, building wiring (for example, the wiring inside the wall that connects a wall socket to a central patch panel) is solid core, while patch cables (for example, the movable cable that plugs into the wall socket on one end and a computer on the other) are stranded. Outer insulation is typically PVC or LSOH. The specific category of cable in use can be identified by the printing on the side of the cable.


http://en.wikipedia.org/wiki/Category_5_cable

 

  • Home|Gallery|Solutions|Products|News|Support|About us |Contact us
  • ICP:05001950  website security